Let's talk about the rolling and cutting process of titanium plates

1. If semi-automatic cutting is performed, the guide rail should be placed on the plane of the titanium plate, and then the cutting machine should be placed on the guide rail. Note that the order cannot be reversed.

2. The cutting parameters should be appropriate and should be reasonably clarified according to the thickness of the titanium plate, so as to obtain good cutting results.

3. Check whether the cutting nozzle gas is unobstructed. If there is a blockage, it should be dredged in time. Gr7 Ti-0.2Pd Titanium Plate / Gr5 Ti-6Al-4V Titanium Sheet / Grade 3 Pure Titanium Plate

4. Before cutting the titanium plate, the surface should be cleaned and a specific space should be left, which can facilitate the blowing of slag.

5. The distance between the cutting nozzle and the surface of the titanium plate should be appropriate. It is not good to be too close or too far.

6. Preheating should be sufficient to avoid affecting the cutting process.

7. If cutting workpieces of different sizes, small pieces should be cut first, and then large pieces.